Iai-america RCS2-A6R Manuel d'utilisateur télécharger pdf (Page 58)

4. Maintenance Inspection

(6) Check the following points before restoring the home position:

� The motor side should be aligned with the initial countermark. If the position is offset, adjust

it to achieve proper alignment.

� The ball screw side should be at a position where the slider projects A4R is 0.6mm, A5R

and A6R is 0.7mm from the mechanical end.

After the check, attach a new belt while holding the pulleys on both sides in position.

�

Initial countermark

position

Corresponding to the slider position

of 0.6mm away from the

mechanical end for A4R or 0.7mm

away for A5R and A6R

Motor side Ball screw side

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 71 72

Pas de commentaire

Iai-america RCS2-A6R Manuel d'utilisateur Page 58