Iai-america IX-NNW8040 Manuel d'utilisateur télécharger pdf (Page 45)

6. Inspection/Maintenance

6.3.5 Checking the Belt Tension for the Rotational Axis

(1) Remove one setscrew provided on a side face of arm 2.

Remove the screw at the center.

(2) Insert a I3 pin in the hole on the side face of arm 2 (pin length: 40 to 80 mm) until the pin lightly

contacts the belt, and then mark a point off C (mm) from the surface of arm 2.

(3) Using a push-pull gauge, push the pin with a force of D (kgf). The belt tension is normal if the mark on

the pin aligns with the surface of arm 2. If not, adjust the belt tension by referring to 6.3.7, “Adjusting

the Belt Tension for the Rotational Axis.”

Type C D

IX-NNW50/60 2.48 (mm) 1.3 ~ 1.5 (kgf)

IX-NNW70/80 3.60 (mm) 1.6 ~ 2.0 (kgf)

z Do not use a pin with a sharp tip that may damage the belt.

z Disassembling the cover provides opportunities for water and powder dust to enter the robot.

Always disassemble the cover in an appropriate environment where water/powder dust will not

enter the robot.

Pulley

Belt

Pulley

rm 2

Mark here

Mark aligns with the

surface of arm 2.

C (mm)

Pulley

D (kgf)

Caution

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 87 88

Pas de commentaire

Iai-america IX-NNW8040 Manuel d'utilisateur Page 45