Iai-america XSEL-KE Manuel d'utilisateur télécharger pdf (Page 340)

325

Appendix

3. Enter the calculation result obtained in step 2 above in the slave-axis fiHOGRI³$[LVVSHFLILF

SDUDPHWHU1R+RPHSUHVHWYDOXH´

o Select [Transfer to Controller] o [Write to Flash ROM] o [Restart Controller] (software reset).

(6) Turn on the servo and check the operation in the jog mode (operate the master axis).

,IDQ³(UURU1R'$'ULYHURYHUORDGHUURU´³(UURU1R&%'HYLDWLRQRYHUIORZHUURU´³(UURU1R

&$6WRSGHYLDWLRQRYHUIORZHUURU´RURWKHU error generates, check the following items:

x If the current position of the master axis deviates significantly from that of the slave axis, the

setting in (5) may be incorrect.

x Check the following parameters to confirm that the required fields are properly filled or changed:

³$[LVVSHFLILFSDUDPHWHU1R0DWLQJV\QFKURD[LVQXPEHU´

³$[LVVSHFLILFSDUDPHWHU1R$%6V\QFKURVODYe-axis coordinate initLDOL]DWLRQFDQFHOODWLRQ´

x Check to see if the slider movements are restricted.

4. Standard Absolute-Reset Procedure

:KHQWKHPDVWHUD[LV DQGVODYHD[LV LQ³$[LVVSHFLILFSDUDPHWHU1R(QFRGHU$%6,1&

W\SH´

$IWHUFRPSOHWLQJ³3RVLWLRQ$GMXVWPHQWRI6\QFKUR$[LV6OLGHUV´SHUIRUPDQDEVROXWHUHVHWIRUWKH

master axis only. For the operation procedure, refer to the operation manual for the X-SEL Controller

or PC software.

Note) A synchro axis that has been reset by the standard procedure is unable to correct any

positional shift that may have occurred while the power was turned off, after the servo is turned

on.

1 2 ... 335 336 337 338 339 340 341 342 343 344 345 ... 423 424

Pas de commentaire

Iai-america XSEL-KE Manuel d'utilisateur Page 340